What in Electronics?
Microcontrollers
-
14:47
6
- 1 Getting Started with STM32 and Nucleo Part 1: Introduction to STM32CubeIDE and Blinky – Digi-Key 14:47
- 2 Getting Started With STM32 and Nucleo Part 2: How to Use I2C to Read Temperature Sensor TMP102 15:03
- 3 Getting Started With STM32 and Nucleo Part 3: FreeRTOS – How To Run Multiple Threads w/ CMSIS-RTOS 12:52
- 4 Getting Started With STM32 & Nucleo Part 4: Working with ADC and DMA – Maker.io 15:06
- 5 Getting Started with STM32 and Nucleo Part 5: How to Use SPI | Digi-Key Electronics 19:30
-
11:54
57
- 1 #0 Modern Embedded Systems Programming: Getting Started 11:54
- 2 #1 How computers count? 17:06
- 3 #2 How to change the flow of control through your code 10:59
- 4 #3 Variables and Pointers 12:22
- 5 #4 How to control the world outside? 16:44
-
4:16
59
- 1 1. How to Program and Develop with ARM Microcontrollers – A Tutorial Introduction 4:16
- 2 2. How to Set up the IDE (Integrated Development Environment) Tutorial for ARM Microcontrollers 4:57
- 3 3. How to Set up the ST-Link v2 Programmer Tutorial for ARM Microcontrollers 1:53
- 4 4. CoIDE – How to Start a New Project with CoIDE (CooCox) Tutorial for the ARM Microcontroller 9:51
- 5 5. How to Connect the STM32 and ST-Link v2 for ARM Microcontrollers – Tutorial and First Circuit 13:46
-
16:25
78
- 1 Introduction to Microprocessors 16:25
- 2 Introduction to Microcontrollers 6:16
- 3 Evolution of Computers (Part 1) 14:33
- 4 Evolution of Computers (Part 2) 17:52
- 5 Evolution of Computers (Part 3) 8:38
-
4:10
29
- 1 Software Install 🔴 PIC Microcontroller Programming Tutorial #1 MPLAB in C 4:10
- 2 Project Setup 🔴 PIC Microcontroller Programming Tutorial #2 MPLAB in C 4:54
- 3 Blinky and Running LEDs 🔴 PIC Microcontroller Programming Tutorial #3 MPLAB in C 7:27
- 4 Buttons as Inputs 🔴 PIC Microcontroller Programming Tutorial #4 MPLAB in C 9:22
- 5 Interrupts 🔴 PIC Microcontroller Programming Tutorial #5 MPLAB in C 10:11
-
16:44
18
- 1 PIC MCU TUTORIALS #1 – MPLABX IDE Installing, Uninstalling & Backing Up Projects (Absolute Beginner) 16:44
- 2 PIC MCU TUTORIALS #2 – How to make MPLABX IDE dark mode & Basic customizations (Absolute Beginner) 11:15
- 3 PIC MCU TUTORIALS #3 – Couple of notes before starting for beginners! (Absolute Beginner) 10:57
- 4 PIC MCU TUTORIALS #4 – Everything you need to start & Uploading our first code! (Absolute Beginner) 20:43
- 5 PIC MCU TUTORIALS #5 – Binary basics & Bitwise operations – Binary Part1 (Absolute Beginner) 24:32
-
12:39
13
- 1 Learn AVR Microcontroller Programming Getting Started 12:39
- 2 Program AVR Microcontroller using AVR USBasp Programmer 6:05
- 3 Blink LED Using AVR Atmega32 Microcontroller 8:11
- 4 Switch with AVR ATmega32 Microcontroller 11:25
- 5 Timer in AVR Atmega32A Microcontroller 13:54
-
25:01
15
- 1 LPC2148 Microcontroller – An Introduction 25:01
- 2 How to Activate LPC2148 Microcontroller 24:26
- 3 Designing Activation Circuit for LPC2148 25:51
- 4 How to use GPIO of LPC2148 Microcontroller 27:04
- 5 Programming LPC2148 Microcontroller 13:15
-
4:36:04
5
- 1 STM32 Full Course for Beginners | CubeIDE, UART, ADC, I2C, SPI, Timers, LCD, SD Card 4:36:04
- 2 STM32 UART Complete Course: Polling, Interrupt, DMA, printf & OneWire 1:49:09
- 3 STM32 ADC Full Course: From Basics to Advanced (DMA, Timer, Injected, Oversampling) 2:33:01
- 4 STM32 Modbus RTU Full Course (HAL + RS485) | Master & Slave Complete Tutorial 1:45:38
- 5 STM32 FreeRTOS Complete Course: Tasks, Semaphores, Mutexes, Notifications and Stack Management 2:26:50
-
6:34
32
- 1 STM32 Tutorial: take your Microcontroller knowledge to the next level 🚀 6:34
- 2 🚀 STM32 Tutorial: Step-by-Step Keil uVision Install & Setup for STM32 Development | Beginner’s Guide 15:44
- 3 🚀 STM32 Tutorial: Keil uVision Project Setup & Practical Example | Master Embedded Systems Dev 23:39
- 4 Arduino Motion detection and graphic engine 2 0:23
- 5 STM32 Tutorial: Binary Code operation & Bit Mask in Keil uVision | Embedded Programming 🚀 19:15
-
49:56
104
- 1 STM32 Tutorial #1 – Overview, Families, Documentation and Development boards and tools 49:56
- 2 STM32 Tutorial #2 – First project in STM32CubeIDE (blink) 36:03
- 3 STM32 Tutorial #3 First Blink (done WRONG!) 10:58
- 4 STM32 Tutorial #4 – Second Blink LED (done RIGHT) 14:39
- 5 STM32 Tutorial #5 – DEBUGGING In-circuit (ST-Link) 14:12
-
9:40
28
- 1 00 STM32 GPIO Output with STM32CubeMX and STM32Cube IDE || HAL Library || 9:40
- 2 01 STM32 GPIO Input with STM32CubeMX and STM32CubeIDE || LED Blink || 12:56
- 3 02 how to use printf function to print string, int and float over uart in STM32 4:23
- 4 STM32 printf Float Not Working? Fix the Float Formatting Issue in Minutes! 1:39
- 5 03 STM32 ADC in Polling mode with STM32CubeIDE || STM32 NUCLEO || 9:48